Live outside the USA?
here to order from a store in your country!

Payment Processing

1. After the belly cast dried, the edges were trimmed with scissors.

2. Then two holes were made at the top of the belly cast with a philips head screwdriver. You could also use a power drill.

3. Latex paints were used to paint the design on the front of the cast.

4. Baby's footprints were put on the front using ProudBody's baby-safe ink pad.

5. The belly cast was finished by spraying a high gloss varnish/shellac on it.
6. Then the ribbon was put through the holes and tied into a knot to hang it up.
live chat software